We spent time this weekend working on the "plumbing" for the fuel tank. As you can imagine the fuel tank needs a vent line installed so that as fuel in removed from the tank it doesn't collapse (think of sucking juice of a juice box, without air coming in the box collapses). We used our flaring tool and straightened out a coil of the vent line. We also started work on the wiring for the fuel sensors and installed the sensing plates. We ran out of a few electrical components that we'll order and have for the next building session.
Scott using the flaring tool on the vent line.
Interior shot of the tank where the vent line attaches.
Exterior shot of the tank where the vent line attaches.
The fuel sensor plate.
No comments:
Post a Comment